This Journal is published by the Centre of Applied Sciences and Technological Development
of the National Autonomous University of Mexico
 
 

Vol. 15
No. 2
 
   
Convenient synthesis, characterization and surface active properties of novel cationic gemini surfactants with carbonate linkage based on C12-C18 sat./unsat. fatty acids
Divya Bajpai Tripathy, Anuradha Mishra

93-101

Enhancement of GdVO4:Eu3+ red flfluorescence through plasmonic effect of silver nanoprisms on Si solar cell surface
Swa Bishnoi, Santa Chawla

102-109
A study of the effects of phenolic de-emulsifier solutions in xylene on the de-emulsifica on of a Nigerian crude oil emulsion
Vincent Enon emonria Efeovbokhan, Joseph Denis Udonne, Ayodedji Adedeji Ayoola, Oluwadara Temitayo Shogbamu, Rasheed Babalola
110-121
Synthesis and characterization of novel α-monomers of peptide nucleic acid
Anjali Gupta
122-131
Room-temperature ferromagnetism in Ni-doped TiO2 diluted magnetic semiconductor thin films
Bushra Parveen, Mahmood-ul-Hassan, Zeeshan Khalid, Saira Riaz, Shahzad Naseem
132-139
Vision-aided system for obtaining a required weight by efficient choice of irregular fragments
Francisco Sánchez Niño, Victor Hugo Compeán Jasso, Francisco Javier De Anda Salazar, Carlos Soubervielle Montalvo, Juan Carlos Muñoz
140-142
Thorax thermographic simulator for breast pathologies
Itzel A. Avila-Castro, Angel Ramon Hernández-Martínez, Miriam Estevez, Martha Cruz, Rodrigo Esparza, Ramiro Pérez, Angel Luis Rodríez


143-151
ACS algorithm tuned ANFIS-based controller for LFC in deregulated environment
Ramesh Kumar Selvaraju, Ganapathy Somaskandan
152-166
Treatment of high saline textile wastewater by activated sludge microorganisms
Hanieh Mirbolooki, Reza Amirnezhad, Ali Reza Pendashteh
167-172
Particle swarm optimization (PSO)-based tuning technique for PI controller for management of a distributed static synchronous compensator (DSTATCOM) for improved dynamic response and power quality
T. Eswaran, V. Suresh Kumar
173-189
Review
Elaboration and characterization of composite material based on epoxy resin and clay fillers

Dalila Laouchedi, Boudjema Bezzazi, Chouaib Aribi
190-204